LG Electronics HCS6320 setup guide Reload the ProIdiom Key on All Transcoders, Operation completed

Configuration Options via Command Line (Cont.)

Reload the Pro:Idiom Key on All Transcoders

This command reloads the Pro:Idiom encryption key on all the transcoders installed in the chassis. To reload the Pro:Idiom key on a single transcoder, see “Reload the Pro:Idiom Key on the Selected Transcoder” on page 41.

1.Access the HCS6320 Main Menu as described on page 30.

2.At the [Main] Command > prompt, type pr and press Enter to initiate the reload immediately.

The system will display progress messages as it reloads the key on each transcoder. When the reload is complete, the system will display confirmation:

Operation completed

Update HCS6320 and/or Transcoder Firmware

If you are not sure of the current firmware version, view and record the System Information for the HCS6320 and/or the transcoder card(s) before you initiate the firmware update. See “View HCS6320 System Information” on page 31 and/or “View Hardware Information for the Selected Transcoder” on page 40, as necessary.

Caution: Do NOT initiate simultaneous menu sessions while a firmware update is in progress. Doing so will interfere with the active processes and may corrupt the system configuration and/or cause the HCS6320 card to cease normal operation.

1.Confirm the directory location of the required firmware update configuration (.cfg) and package (.pkg) files. Note: For a TFTP file transfer, the firmware update files must be available on the same machine as the TFTP server.

2.Access the HCS6320 Main Menu as described on page 30.

3.At the [Main] Command > prompt, type upd and press Enter.

4. At the Enter card number (1-12, ‘ctr’, or ‘all’) > prompt, either:

•Type the slot number of the card and press Enter to update a single transcoder card.

•Type all and press Enter to update each of the transcoder cards.

•Type ctr and press Enter to update the HCS6320 firmware.

5. At the Use TFTP to transfer files (y/n)? prompt, either:

•Type y and press Enter to use TFTP for the firmware update.

•Type n and press Enter if you will not use TFTP for the firmware update. At the next system prompt: Use XMODEM to transfer files (y/n)?, type y and press Enter.

6.Refer to the appropriate subsection below, depending on the file transfer option used.

(Continued on next page)

206-4183 35