LG Electronics LF300CP(LP-C303R20), LF480CE(LP-C483TA0) service manual Soft Dry Operation Mode

8.Soft Dry Operation Mode

•During Soft Dry Operation, the compressor ON temperature is the setting temperature plus 2°C(3.6°F), the compressor OFF temperature is the setting temperature minus 1°C(1.8°F).

•When the room temperature rises over the compressor ON temperature, the operation mode is switched to the Cooling mode.

•When the room temperature falls between the compressor ON temperature and OFF temperature, the operation mode is switched to the Soft Dry Operation.

•The operation diagram is shown below.

Intake Air Temp.	Operation		Dry operation		Cooling
	Cooling				operation
Setting Temp. +2°C(3.6°F)
(Compressor ON)
Setting Temp. -1°C(1.8°F)		3 min.	10 min.	maximum		3 min.	maximum
(Compresso OFF)
				7 min.			10 min.
Indoor Fan Speed	Selecting	LOW	LOW	LOW	Selecting	LOW	LOW	LOW
	fan speed				fan speed
Compressor	ON	OFF	ON	OFF	ON	OFF	ON	OFF

9.Protection of the evaporator pipe from frosting

•Compressor and outdoor fan stop when indoor pipe temperature is below -2°C(28.4°F) and restart at the pipe temperature is above 12°C(53.6°F).

10.Air Purifying Operation(AP-Z286RC0, AP-Z286R20, AP-Z488TC0)

Mode Selecting		Operating Mode		Fan Speed		Outdoor		OFF
Initial Starting of		- Outdoor not operating		- Low at the initial
Air purifying		- Fan operating + Air		- But could be		OFF	Repress Air
Operation				switched to Med. Hi
		purifying operating					purifying
							Button or
							ON/OFF
					ON or OFF
When switched to	- Outdoor operating		Selecting Speed of				Button
					depend on main
Air purifying	- Main Operating +		Main Operating Mode
					operating
operation		Air purifying operating
					condition.

11. Child Lock function

This function is to operate Air conditioner only by Remocon.

The procedure is as the following

1st: Press the 2 buttons of the temperature control simultaneously, to raise-to lower on the Display Panel of the product for more 3 seconds.

2nd: The buzzer sounds and then the window of Display Panel shows CL (CL) mark.

3rd: To release this function, the reverse again the operating procedure could be done.

❈During this function is operating, any buttons of Display Panel don't work. But it is possible to operate with Remote controller.

–20–