LG Electronics LHY-518 Connections, Connecting Antenna/Cable TV to Recorder Combi Receiver, Ips

Connections

ips

Depending on your TV and other equipment you wish to connect, there are various ways you could connect the Recorder Combi Receiver. Use only one of the connections described below.

Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

Caution

Make sure the Recorder Combi Receiver is connect- ed directly to the TV. Tune the TV to the correct video input channel.

Do not connect the Recorder Combi Receiver’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

Do not connect your Recorder Combi Receiver via your VCR. The DVD image could be distorted by the copy protection system.

Connecting Antenna/Cable TV to Recorder Combi Receiver

1	Disconnect the antenna leads from the rear of the
	TV.

2 Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a 75 ohm coaxial antenna cable. This cable will connect directly to the jack marked ANT.IN on your Recorder Combi Receiver.

ip

If your antenna lead wire is a flat type antenna cable, connect it to an Antenna Adapter (300-ohm to 75-ohm) (not supplied) and slip the Adapter onto the ANT.IN jack. The Adapter does not screw on to the Recorder Combi Receiver, it just slips over the jack.

DVD/VCR

OUT

Cable Service Without Cable Box

If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the ANT.IN jack on the Recorder Combi Receiver. Use the supplied round coaxial cable to connect between the Recorder Combi Receiver’s RF.OUT jack and the 75 ohm antenna input jack on the TV. With this connection, you can receive all mid- band, super band, and hyperband channels. (All cable chan- nels.)

Cable Service With Cable Box

If a converter is required in your cable system, follow the instruction below:

The cable hookup permits both TV and Recorder Combi Receiver operation.

To view or record a CATV channel

1Tune the TV to the correct video input channel.

2Set the Recorder Combi Receiver channel selector to the output channel of the Cable Converter box using TRK/ PRESET(-/+) (v / V) or number (0-9) of your Recorder Combi Receiver. (Example: CH3)

3Select the channel to view at the Cable Converter Box.

ote

If you are using a cable box to tune channels, it is not neces- sary to do Auto Channel Set as indicated on page 26.

Cable TV

Wall Jack

Back Panel of

Typical Cable Box

DVD/VCR

OUT

16