LG Electronics LKD-8DS, GDK-20W General Description, Introduction, To Enter the Programming Mode

GDK-20W DIGITAL WIRELESS KEY TELEPHONE SYSTEM

SECTION 6. ADMIN PROGRAMMING

6.1 GENERAL DESCRIPTION

6.1.1 INTRODUCTION

The GDK-20W Key Telephone System can be programmed to meet each customer's individual need. All programming is done at station 100(DKT 1) using KD-24D, KD-36D, LKD-30D digital key telephone.

Upon entering the program mode, the key telephone at station 100 cannot operate as a normal telephone but as a programming instrument with all of the buttons redefined. The keys of the dial pad are used to enter the various data fields and to enter numerical information. The 24 buttons located at the top of the phone (Flex Buttons) are used to indicate the specific data field and to enter information. Sometimes [SPEED] button is used to delete the data.

See TABLE 6.2.2.1 - 6.2.2.10 for default data. If this pre-programming suits the customer, additional Admin program is not necessary. To change admin data, the user enter the admin. programming mode and select program code. During Admin programming, other keysets in the system operate normally.

When Admin programming, LCD and LED’s indicate current programmed data and status. If the programmer enters correct data, then LCD and LED’s show the entered data and the data is stored in the temporary buffer area. Real system databases is not changed and has no effect on telephone operation unless permanent updating procedure is executed. Pressing [HOLD/SAVE] button, all data in the temporary buffer (same as LCD and LED’s show their status) is saved into permanent memory. Tones are provided to let the programmer know whether data entry is correct (confirmation tone) or not (error tone).

6.1.2 TO ENTER THE PROGRAMMING MODE

1.Lift handset or press the [MON] button on the admin station, and hear ICM dial tone (optional),

2.Press [TRANS/PGM] button and dials *# (confirmation tone heard),

3.Enter Admin. Password if the password has programming mode (confirmation tone heard). LCD)

been set. This procedure places the station into the Admin. And LCD will displays the first step of Admin. programming.(below

ADMIN PROGRAM START PRESS FLEX KEY(1-12)

84