Connections (Continued)
HD Monitor RGB Connections
Antenna |
Cable TV
Wall Jack Panel
HD Ready TV Connection Panel
ANTENNA | AUDIO INPUT | VIDEO | RGB INPUT | |||
INPUT | INPUT | INPUT | ||||
|
|
| ||||
|
| L | R |
|
| |
INSTALLATION
OR
DVD/HDTV Receiver Connection Panel
11 Connect the “Antenna/Cable” to the “ANT IN” jack on the DVD/HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the antenna to an optional attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 12.)
| Connect the “ANT LOOP OUT” jack on the DVD/HDTV Receiver to the “Antenna In” jack on your TV using a |
2 coaxial RF cable. | |
| Connect the “RGB OUT” jack on the DVD/HDTV Receiver to the “RGB IN” jack of your TV using |
3 nector. (The Output Selection must be set to RGB, refer to Setting the Display Format on page 19) | |
4 | Connect the L/R “AUDIO OUT” jacks on the DVD/HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using |
ote
The RGB output is useable if 1080i, 720p, 480p, native, variable 1, variable 2, or variable 3 display for- mat is selected.
15
