INSTALLATION 5
INSTALLATION
How to fix anchors and screws
CAUTION
yyCheck the wall materials and the thickness of finishing materials.
yyYou can use the anchors and bolts provided with the Laser Display set for walls made from concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick or cellular blocks.
yyWhen installing it on a wall not specified in this manual, make sure each fixing point withstands an uplifting load of 70 kgf (686 N) and a shearing load of 100 kgf (980 N) or more.
(Attach a plate such as plywood to strengthen the wall before installation.)
a. At each anchor position, use a 8 mm drill bit to make a hole with a depth of 80 mm - 100 mm.
b. Clean the holes.
c. Insert the anchors provided into each hole. (Use a hammer when inserting the anchor.)
d. Fix a part in place by aligning it with the screw hole.
Tighten the screw with a torque 45 kgf/cm - 60 kgf/cm or higher.
a |
Drilling hole
b
Cleaning hole
Anchor
c
Inserting anchor
Fixing ring and space steel
d
Screw for fixing ring and | Screw for fixing ring and space steel |
space steel |
|
