LG Electronics 1302-REV00, MFL67652408 Installation Procedure (Stand Type)

6INSTALLATION

Installation Procedure (Stand Type)

1 Install the guide pins at the bottom of the set.

2 Connect the connection rod to the Ez bracket main unit and place it on a table,

without the ﬁxed components, at the center of the screen.

NOTE

yy Do not assemble the fixed components to the unit yet.

Contents

Main Safety Precautions Installation Page PREPARATION Accessories Preparations INSTALLATION How to x anchors and screws CAUTION Installation Procedure (Stand Type) Page Page 9 10 mm Page Page Page 22 Two people must lift the screen above the guide tape and hang it on the rings. CAUTION Page 25 Check that the right and left sides of the screen are parallel to the wall using a If the screen is not parallel to the wall If the screen does not stay level Page Ez Bracket Adjustment Guide 1. Reset projection 2. Adjust the projection to t within the screen 3 1 2 3. Adjust the left and right widths of the projection so they are equal 1 2 Page Page 6. If the projection is rectangle-shaped,