29
ENG
English
Using PCoIP Solution
USIng PCoIP SolUtIon
Selecting the Connect button initiates a PCoIP or
RDP session depending on the session settings.
While the PCoIP connection is pending, the OSD
local GUI will display a "Connection Pending"
message. When the connection is established, the
OSD local GUI will disappear and be replaced by
the session image.
oSD options Menu
Selecting the Options menu will produce a list of
selections. The OSD Options menu contains:
yConfiguration
yDiagnostics
yInformation
yUser Settings
A red "X" over the network icon indicates that
either the network is not properly connected or that
the connection is still being initialized (i.e. during
portal boot up). Figure 2-2 shows the red "X" over
the network icon indicating that the network is not
ready.
Figure 2-3 shows the network icon when ready.
Figure 2-1. OSD Connect Screen
Figure 2-4. OSD Connect Screen (Connecting)
Figure 2-3. Network Ready (Detail)
Connect Screen
The Connect screen is shown during start-up,
except when the portal has been configured for a
managed start-up or auto-reconnect. The logo dis-
played above the Connect button can be changed
by uploading a replacement image via the admin
interface. The network icon on the bottom right of
the Connect screen shows the status of the net-
work connection. You must wait until the network
icon is displayed as shown in Figure 2-3.
Selecting one of the options will produce a settings
window.
Figure 2-2. Network Not Ready (Detail)
notE
yMenus and functions in PCoIP mode may be
slightly different depending on the firmware
version.The manual for each version can be
downloaded from the Teradici website: http://
www.teradici.com.
yFor information on how to check the firmware
version,See p.39.