31
ENG
English
Using PCoIP solution
Figure 2-7. Label Configuration
label Tab
The Label tab allows the administrator or host to
add customized information to the portal.
yThe portal label parameters can also be con-
figured using the Webpage Administration
Interface.
yIn order to utilize the FQDN feature, a DNS
server, configured properly with DHCP option
81, must be used.
yGateway
The Gateway field contains the gateway IP ad-
dress of the device. If DHCP is disabled, this field
is required. If DHCP is enabled, this field cannot be
edited.
yPrimary Dns server
The Primary DNS Server field contains the primary
DNS IP address of the device. This field is option-
al. If DHCP is enabled, this field cannot be edited.
ysecondary Dns server
The Secondary DNS Server field contains the sec-
ondary DNS IP address of the device. This field is
optional. If the DHCP is enabled, this field cannot
be edited.
yDomain name
The Domain Name field contains the domain name
used, e.g. "domain local". This field is optional. It speci-
fies on which domain the host or portal operates.
yfQDn
The FQDN field represents the Fully Qualified Do-
main Name of the host or portal. The default value is
PCoIP-host-MAC or PCoIP-portal-MAC, where MAC
is the MAC address of the host or portal. If there is
a domain name, it will be added to the FQDN in the
format of PCoIP-host-MAC.domain.local
yPCoIP Device name
In the PCoIP Device Name field, the administrator
can specify a logical name to the host or portal.
The default value is PCoIP-host-MAC or PCoIP-
portal-MAC, where MAC is the MAC address of the
host or portal.
yPCoIP Device Description
In the PCoIP Device Description field, the administra-
tor can add specific information, such as the endpoint
location, or add a description to the host or portal.
This field cannot be used in the PCoIP firmware and
accessibility is strictly limited to the administrator.
yGeneric Tag
In the Generic Tag field, the administrator can add a
generic tag to the host or portal.
This field cannot be used in the PCoIP firmware and
accessibility is strictly limited to the administrator.
yEthernet Mode
The Ethernet Mode field specifies the portal's Eth-
ernet mode.
The available options are as follows.
yAuto
y100 Mbps Full-Duplex
y10 Mbps Full-Duplex
If another network device is configured to oper-
ate under 10 Mbps Full-Duplex or 100Mbps Full-
Duplex, the administrator should always set the
Ethernet Mode field to Auto and only use 10 Mbps
Full-Duplex or 100 Mbps Full-Duplex.
noTE
noTE