LG Electronics RU-52SZ30 Programming the Remote, Press the Power button and the Mute but

Programming the Remote

	The remote control of your HD receiver is a multi-
	brand or universal remote control that can be
	programmed to operate most remote-controllable
	devices of other manufacturers.
	Note that the remote control may not control all
	models of other brands.
1	Test your remote control.
	To find out whether your remote control can
	operate the component without program-
	ming, turn on the component such as the
	VCR and press the corresponding mode but-
	ton (VCR) on the remote control while
	pointing at the component. Test the POWER
	and CH +/- buttons to see if the component
	responds properly. If not, the remote
	requires programming to operate the device.
2	Turn on the component to be programmed.
	Then press the corresponding mode button
	on the remote control.
3	Press the POWER button and the MUTE but-
	ton simultaneously. Then the remote control
	is ready to program the code for the corre-
	sponding component.
4	There are two ways to find the right code for
	the component.
	A. If you press the CH +/- buttons repeat-
	edly, the code will change one at a time.
	Press the POWER button after each code
	change. If the right code is found, the
	device will turn off.
	B. Enter a code number using the number
	buttons on the remote. The right code num-
	bers for the corresponding component can
	be found on the following pages.
	Again, if the code is correct, the device will
	turn off.
5	Press the EXIT button to store the program.
6	Test the remote control functions to see if
	the component responds properly. If not,

repeat from step 2.

2

4

3

tv	vcr cable	dvd sat
mode	light	power
tv/video	front	dvi
comp1	comp2	rgb

1	2	3
4	5	6
7	8	9
enter	0	flashbk

mute			surf
sap			video
	vol	ch
pip	pipch-	pipch+	swap
ratio	cc	freeze	pip input

menuexit

play pause stop record

rew ff

skip

3

4

5

P A G E 4 5