Press the ON/OFF key to select the alarm on or off (if the alarm is enabled, the alarm icon
will be turned on).
4. Outdoor Temperature Low Alarm. Press the enter key to set the outdoor temperature low
alarm function. The outdoor temperature and LO AL (high alarm) will begin flashing.
5.
Press the up key or down key to change the value.
Press the ON/OFF key to select the alarm on or off (if the alarm is enabled, the alarm icon
will be turned on).
6. Outdoor Temperature Record High. Press the enter key to display maximum outdoor
temperature record since the last reset. The maximum temperature record and MAX icon (in
the tendency section) will begin flashing. To reset, press the enter key for 3 seconds, and the
maximum value (and associated date and time) will be reset to current reading.
7. Outdoor Temperature Record Low. Press the enter key to display minimum outdoor
temperature record since the last reset. The minimum temperature record and MIN icon (in
the tendency section) will begin flashing. To reset, press the enter key for 3 seconds, and the
minimum value (and associated date and time) will be reset to current reading.
8. Repeat the above steps for wind chill and dew point.
Please reference Section Indoor Humidity. The outdoor procedure is similar to the indoor humidity
procedure.
Note: This is a continuation of the previous section. To enter this mode, you must begin at
Section 5.1 and proceed to this section.
5.12 Memory The console stores up to 4080 complete sets of weather data with associated time and date stamp. The
base station will lose all of the weather data if there a power interruption. In the event the memory is
full, the old data is overwritten by the new data.
Press the history key to review the historical data.
1. Select the down key to review historical data archived in the console. Select the up key to
advance historical data archived in the console (default is 30 minute intervals).
When history data displayed, the corresponding date and time will be displayed at the time
section area.
The historical archive interval can only be changed using the PC software that comes with
this product. The factory default archive interval is 30 minutes.
2. Clear Memory. Press the history key to clear memory. The memory fill icon will be flashing.
Version 1.10 ©Copyright 2011, Ambient LLC. All Rights Reserved. Page 25