Kit No. | 08 Sep 2008 |
Document No. |
17.Install the new snap ring (see Figure 12)
18.Pull the rocker arm against the snap ring.
Fig 12: installing the snap ring
19.Slide the shaft collar tightly against the Oilite washer and rocker arm housing (see Figure 13).
Fig 13: pull the shaft collar in the direction of the arrow
20.Tighten the setscrew on the shaft collar (see Figure 14).
21.Swing the rocker arm to verify free movement. This will also provide assurance that the Loctite has not seized the bearing and sleeve together.
22.Reattach the user arm and pedal to the rocker arm.
23.Reattach the lower rocker arm cover.
24.Reattach the outer deadshaft cover.
25. Repeat steps | Fig 14: tightening the shaft collar |
arm. The Loctite on the first side will be |
|
curing while the second rocker arm kit is |
|
being installed. |
|
26.Allow the Loctite on the second rocker arm kit to cure undisturbed for at least 30 minutes.
5
