LightSpeed Technologies Delta X10, X12 manual Operating Instructions, System Base Unit

Delta X10

						Wireless
					Sound System
WIRELESS MIC 1					WIRELESS MIC 2
					REPEAT	A — B	STOP		PLAY/PAUSE PROG
		CD-ROM ART GOES HERE
NO diSC					EJECT	— SKIP —				SCAN/SEARCH
LINE	LINE/CD LEVEL		VOICE OVER MUSIC				TONE CONTROL
I							0			0
N
O
U			-dB40	dB0		–			+	– HIGH +
T	min	max					LOW
IN	LEVEL					IN	LEVEL
1			LOW CUT							LOW CUT	2
MIC			music speech							music speech	MIC
	min	max				min			max
MASTER			BATTERY				LOW CUT			LOW CUT
VOLUME			STATUS
LIMIT						music		speech		music speech
	min	max			LOW OK	WIRELESS				WIRELESS
	LEVEL						MIC 1			MIC 2
EXTERNAL
SPEAKER A
SWITCHED
8 OHM
EXTERNAL			LightSPEED							CHARGING STATUS
SPEAKER B			MADE IN EUROPE			EXTERNAL
8 OHM
							POWER
						SOURCE
							12VDC/4A
							4	1
ON MUTE							3 2		GND
							+ 12V
POWER		DO NOT OPEN			ACTIVE		MAINS
			THE COVER.		LINK		AC
	ON	REFER SERVICING					90-264V
		TO QUALIFIED
	OFF		PERSONNEL.				47-63Hz
		REPLACE FUSE					FUSE
			ONLY WITH
	MUTE	THE SAME TYPE					T2A
			AND RATING.

Operating Instructions

System Base Unit

VOICE OVER MUSIC					TONE CONTROL
3				4	0			0
- 40		0		–	LOW	+	–		+
dB		dB						HIGH
LINE	LINE/CD LEVEL		VOICE OVER MUSIC		TONE CONTROL
I					0		0
N
O
U			- 40	0	–	+	–	+
T	min	max	dB	dB	LOW		HIGH
IN	LEVEL				IN LEVEL
MIC 1				LOW CUT			LOW CUT		MIC 2
				music speech			music	speech
	min	max			min	max
MASTER				BATTERY	LOW CUT		LOW CUT
VOLUME				STATUS
LIMIT					music	speech	music	speech
	min	max		LOW	OK
					WIRELESS		WIRELESS
	LEVEL
					MIC 1		MIC 2

1

2

LIMIT min max

LEVEL

1.MASTER VOLUME: The MASTER VOLUME control is used to set the overall level of the audio going to the speaker(s). Each individual input has its own level control, and all of these input signals are combined (mixed) into one signal that flows through the MASTER VOLUME control.

2.LIMIT: The LIMIT LED lights up to indicate when the limiter is active. The limiter helps to prevent distortion which can cause damage to the speaker system. The level of the signals coming from the inputs (microphones, CD player, LINE IN) is ‘watched’ by the limiter circuit. The limiter instantly reduces the signal to a safe level if it becomes too large. When the limiter light is on, the power amplifier has reached maximum power.

3.VOICE OVER MUSIC: This is a special feature that automatically reduces the level of the LINE/CD inputs whenever sounds are produced at any of the four microphone inputs (WIRELESS MIC 1, WIRELESS MIC 2, MIC 1 IN, and MIC 2 IN). After a few seconds of silence on the microphones, the LINE/CD signal will slowly return to its original volume level. This is handy for events that require background music with occasional announcements.

The VOICE OVER MUSIC control sets the amount of reduction in level that occurs when the circuit is triggered by a micro- phone signal. For less reduction of the LINE/CD signal, turn the VOICE OVER MUSIC control clockwise. To disable VOICE OVER MUSIC, turn the control fully clockwise.

4.TONE CONTROLS: The LOW and HIGH controls provide the ability to cut or boost the corresponding frequencies in the LINE/CD signal. These controls do not affect the microphone signals.

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662 11