LightSpeed Technologies X12 Wireless Transmitter, Operating Instructions, Handheld Microphone

Operating Instructions

Wireless Transmitter

Handheld Microphone

Channel Selection – Handheld Transmitter

Once a channel has been selected on the receiver, you now need to select that same channel on the handheld transmitter. If you have a belt-pack transmitter, go to page 23 for channel selection instructions.

•Turn the microphone on by sliding the switch on the barrel to the ON position. The red LED will flash once.

•Use the “up” and “down” buttons to select a screen that shows the current channel.

•To change the channel, press and hold the “SET” button on the bottom of the microphone until there is a blinking cursor on the LCD display

window (approximately 3 seconds).

Setup Screens
selectable with				NiMH
the UP and DOWN				AKLN
	Arrow Buttons
			CH: 002	SENS SET
				LEVEL [2]
		CH: 002		LS
	720.500M			HM-900

NOTE: Transmitters and receivers are available in 5 different frequency groups. Verify that the letter code that blinks on the receiver (when powered ON) matches the letter code on the frequency sticker in the battery compartment of the transmitter.

LOCK SET

LOCK SET

DOWN UP

HM-900

•Use the “UP” and “DOWN” buttons to set the channel to match the receiver.

•Press and hold the “SET” button again until the blinking cursor disappears and the red LED flashes (approximately 3 seconds).

Red

LED

ON/OFF Switch

ON

LCD Display

Transmission Frequency in MHz: Press the “UP”

button once to view the transmission frequency in CH: 002

720.500M

MHz of the currently selected channel.

Lock Function

This allows users to lock out all the controls on the microphone so that it is not accidentally switched off or the channels aren’t accidentally changed in the middle of a performance.

To lock all the controls:

•Press the “LOCK” button on the bottom of the microphone. A lock icon will appear on the LCD screen next to the channel number.

CH: 002

LOCK SET

HM-900

LightSPEED

Rotate Disc to Secure

Controls

•The black (or colored) disc on the bottom can be rotated around to completely cover the controls so that the buttons cannot be accidentally pressed again.

To unlock all the controls:

•Rotate the black (or colored) disc back around to reveal the buttons on the bottom of the microphone.

•Press the “LOCK” button again to unlock. The lock icon will disappear.

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662 20