LightSpeed Technologies X12, Delta X10 Wireless Transmitter, Operating Instructions, Belt-pack

Models: Delta X10 X12

1 35
Download 35 pages 25.06 Kb
Page 26
Image 26
5. To Change the Battery Type Setting:

LightSPEED

Operating Instructions

Wireless Transmitter

Belt-pack

CH: 001

2 Gain Adjust

720.250M

1

GT MT

CH: 0016.Replacing the Batteries:

LightSPEED3

GT

MT

Alkaline Typical battery life is about 8 hours.Manual background

4

NiMH

Nickel Metal Hydride

Rechargable

1.Transmitter Mute: The MUTE switch turns the transmitter’s audio signal on or off. The audio is off when the red LED is flashing.

2.Gain Adjust: When changing microphones or users, it may be necessary to adjust the transmitter gain based on differing microphone sensitivities and voice levels.

•To adjust the microphone gain, turn the MT dial clockwise to increase the gain and counterclockwise to decrease the gain.

•If you are using a high impedence source, such as a guitar, it will be necessary to adjust the GT dial. Using a high impedance source requires a special cable. Contact LightSPEED Technologies for more information.

3.Battery Life Indicator: The battery life is shown on the primary screen of the LCD. The 7-step fuel gauge acts as a detailed guide to show the actual life of the battery.

4.Battery Type: The transmitter will operate with either standard Alkaline Batteries or Nickel Metal Hydride (NiMH) Rechargable Batteries. Since these types of batteries have different characteristics, it is important to set the transmitter to the appropriate type of battery being used so that the battery life indicator will operate properly.

NOTE: Do not mix battery types.

WARNING: Do not use NiCad batteries! They will not charge properly and may cause damage to the transmitter.

5. To Change the Battery Type Setting:

•Press the “UP” button twice to get to the battery type screen.

•Press and hold the “SET” button until a blinking cursor appears.

•Use the UP and DOWN buttons to make a selection.

•Press and hold the “SET” button again until the blinking cursor disappears.

6.Replacing the Batteries:

•Open the plastic door by depressing the latches on each side.

•Insert two AA batteries and snap the door closed. Note the polarity in the battery compartment.

Typical battery life is about 8 hours.

Battery

Compartment

Manual background NiMH

AKLN

5

UP

Button

Set

Button

 

GT

 

MT

6

Door

 

Latch

 

DOWN

 

Button

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662

24

Page 26
Image 26
LightSpeed Technologies X12 Wireless Transmitter, Operating Instructions, Belt-pack, To Change the Battery Type Setting