B-8

OPERATION

B-8

 

 

 

PULSE WELDING

Pulse welding procedures are set by controlling an overall "arc length" variable. When pulse welding, the arc voltage is highly dependent upon the waveform. The peak current, back ground current, rise time, fall time and pulse frequency all affect the voltage. The exact voltage for a given wire feed speed can only be predicted when all the pulsing waveform parameters are known. Using a preset voltage becomes impracti- cal, and instead the arc length is set by adjusting "trim".

Trim adjusts the arc length and ranges from 0.50 to 1.50, with a nominal value of 1.00. Trim values greater than 1.00 increase the arc length, while values less than 1.00 decrease the arc length.

Most pulse welding programs are synergic. As the wire feed speed is adjusted, the Power Wave will automati- cally recalculate the waveform parameters to maintain similar arc properties.

The Power Wave utilizes "adaptive control" to com- pensate for changes in electrical stick-out while weld- ing. (Electrical stick-out is the distance from the contact tip to the work piece.) The Power Wave waveforms are optimized for a 0.75" (19mm) stick-out. The adaptive behavior supports a range of stickouts from 0.50" (13mm) to 1.25" (32mm). At very low or high wire feed speeds, the adaptive range may be less due to reach- ing physical limitations of the welding process.

Arc Control, often referred to as wave control, in pulse programs usually adjusts the focus or shape of the arc. Wave control values greater than 0.0 increase the pulse frequency while decreasing the background cur- rent, resulting in a tight, stiff arc best for high speed sheet metal welding. Wave control values less than 0.0 decrease the pulse frequency while increasing the background current, for a soft arc good for out-of-posi- tion welding.

(See Figure A.6)

FIGURE A.6

CURRENT WAVE FORM (PULSE)

Current

Wave Control -10.0

Wave Control 0.0

Wave Control +10.0

Time

POWER WAVE 455M/STT (CE)

Page 28
Image 28
Lincoln Electric IM924 manual Pulse Welding, Figure A.6 Current Wave Form Pulse