MAINTENANCE | ||
|
|
|
FIGURE D.2
NOTE: The cable contains three control leads. Any two control leads can be used, provided the two color used are the same at both ends. The extra lead is a spare that can be used if one of the other leads breaks
g.Check that the cable boot and both halves of the strain relief are on the cable. Slip the connector nut over the copper strands with the thread end out. Orient gun tube connector so machined flat is on the same side of the cable as the red and white control leads. Assemble gun tube connector to cable by forcing the steel tube of the connector into the inside diameter of the cable inner tube until the copper strands are butted against the gun tube connector shoulder. Keeping the copper strands against the shoulder, pull the connector nut over the copper strands, engage the gun tube connector threads, and tighten in place. Figure D.2.
NOTE: For best results, insert a .175/.197 inch (4.5-
5.0mm) diameter rod through the connector and into core of cable approximately 5.00 inch (127 mm) when pushing the connector tube into the cable core tube.
To tighten, hold the connector in place while turning the nut, and remove the rod from the core, The proce- dure ensures the inner core does not kink while assembling or tightening.
h.Pull the
i.Position the cable boot and strain relief on the cable so it fits in cable handle cavity and lock the strain relief in place by pushing the two halves together.
j.Assemble cable in left side of gun handle. Assemble trigger into the proper handle cavity and connect the control leads. Assemble right side of gun handle and tighten the three screws that hold the handle together. Refer to Figure D.3.
k.Install gun tube per Gun Tubes and Nozzles Section.
l.Install and trim liner per Liner Installation Section.
