![](/images/new-backgrounds/1258494/258494221x1.webp)
Return to Section
Return to Master
5.Using a 5/16” nut driver remove the four screws from the top and bottom of the front of the machine. See Figure F.31.
6.Using a phillips head screwdriver remove the six screws and their washers from around the input power switch. See Figure F.31.
7.Using a phillips head screwdriver remove the four screws from around the two welder output termi- nals on the front of the machine. See Figure F.31.
8.The front of the machine may now gently be pulled forward to gain access to the status Board. Note: The front of the machine cannot be removed completely, only pulled forward a few inches.
9.The status board is now accessible to replace.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE F.31 – FRONT SCREW REMOVAL
5/16" Screws
AMPS |
|
| V OLTS |
| |
CONTROL |
|
| WELD TERMINALS | ||
REMOTE |
|
| REMOTE | ||
LOCAL |
| OUTPUT | ON | ||
|
|
| |||
SELECT |
|
|
| SELECT | |
m WELD MODE |
| HOT START | ARC CONTROL | ||
| 5 |
| 0 | ||
4 | 6 | ||||
|
| +2 | |||
3 | 7 | +4 | |||
TIG GTAW | 2 | 8 | +6 | ||
| |||||
1 | 9 | +8 | |||
SELECT | |||||
| |||||
| 0 | +10 | |||
|
| 10 | |||
|
|
| SOFT | CRISP |
Welder Output | ON | OFFOFFOFF | Input Power |
|
| ||
Terminal Screws |
|
| |
OFF |
| Switch Screws | |
|
|
5/16" Screws