ADSL Gateway
Chapter 4: Connecting the ADSL Gateway
Overview
The installation technician from your ISP should have left the setup information for the modem with you after installing your broadband connection. If not, you can call your ISP to request that data.
After you have the setup information you need for your specific type of Internet connection, you can begin installation and setup of the Gateway. Continue to “Connecting the Gateway to a Computer.”
Connecting the Gateway to a Computer
1. Make sure that all of your network’s hardware is powered off, including the Gateway and all computers. |
|
2. Connect a phone cable from the Line port on the Gateway’s side panel to the wall jack of the ADSL line. A |
|
small device called a microfilter (not included) may be necessary between each phone and wall jack to |
|
prevent interference. Contact your ISP if you have any questions. |
|
NOTE: A small device called a microfilter (not included) may be necessary between each phone |
|
and wall jack to prevent interference. Contact your ISP if you have any questions. |
|
IMPORTANT: For countries that have phone jacks with | Figure |
| |
the microfilters between the phone and the wall jack and not between the Gateway and the wall |
|
jack or your ADSL will not connect. |
|
For countries that do not have phone jacks with |
|
Switzerland, United Kingdom, etc.), except for ISDN users, the microfilter has to be used between |
|
the Gateway and the wall jack, because the microfilter will have the |
|
Annex B users (E1 and DE versions of the Gateway) must use the included special cable to connect |
|
the Gateway to the wall jack |
|
contact your service provider. |
|
Chapter 4: Connecting the ADSL Gateway | 9 |
Overview
