Chapter 1
Product Overview
Side Panel
Reset There are two ways to reset the Router’s factory defaults. Either press and hold the Reset button for approximately ten seconds, or restore the defaults from the Administration > Factory Defaults screen of the Router’s
NOTE: Restoring the voice defaults may require your login (the default user name and password are admin). If the defaults do not work, contact your ITSP for more information.
Stand To place the Router in a vertical position, rotate the stand 90 degrees.
Placement Positions
There are three ways to physically install the Router. The first way is to place the Router horizontally on a surface. The second way is to stand the Router vertically on a surface. The third way is to mount the Router on a wall.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Place the Router on a level surface near an electrical outlet.
Vertical Placement
The Router has a stand on the panel opposite to the antenna. Rotate the stand 90 degrees, and place the Router on a level surface near an electrical outlet.
Wall-Mounting Placement
The Router has four
Two screws are needed to mount the Router.
Suggested Mounting Hardware
2.5 | |||
|
|
†Note: Mounting hardware illustrations are not true to scale.
NOTE: Linksys is not responsible for damages incurred by insecure
Follow these instructions:
1.Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.
2.Drill two holes into the wall. Make sure the holes are 60 mm (2.36 inches) apart.
