Chapter 3

Advanced Configuration

Hardware Version  The version number of the Router hardware is displayed.

MAC Address  The MAC address of the Router is displayed.

Client Certificate  The status of the client certificate, which indicates that the Router has been authorized by your ITSP, is displayed.

System Status

Current Time  The current date and time of the Router are displayed.

Elapsed Time  The amount of time elapsed since the last reboot of the Router is displayed.

RTP Packets Sent  The number of RTP packets sent by the Router is displayed.

RTP Bytes Sent  The number of RTP bytes sent by the Router is displayed.

RTP Packets Recv  The number of RTP packets received by the Router is displayed.

RTP Bytes Recv  The number of RTP bytes received by the Router is displayed.

SIP Messages Sent  The number of SIP messages sent by the Router is displayed.

SIP Bytes Sent  The number of SIP bytes sent by the Router is displayed.

SIP Messages Recv  The number of SIP messages received by the Router is displayed.

SIP Bytes Recv  The number of SIP bytes received by the Router is displayed.

External IP  The external IP address used for NAT mapping is displayed.

Line 1/2 Status

Lines 1 and 2 have the same status information available.

Hook State  The status of the Internet phone line’s readiness is displayed. “On” indicates that it is ready for use, while “Off” indicates that it is in use.

Registration State  The status of the line’s registration with the ITSP is displayed.

Last Registration At  The last date and time the line was registered are displayed.

Next Registration In  The number of seconds until the next registration is displayed.

Message Waiting  This indicates whether you have new voicemail waiting.

Call Back Active  This indicates whether a call back request is in progress.

Last Called Number  The last number called is displayed.

Last Caller Number  The number of the last caller is displayed.

Mapped SIP Port  The port number of the NAT mapped SIP port is displayed.

Calls 1 and 2 have the same status information available. Call 1/2 State  The status of the call is displayed.

Call 1/2 Tone  The type of tone used by the call is displayed.

Call 1/2 Encoder  The codec used for encoding is displayed.

Call 1/2 Decoder  The codec used for decoding is displayed.

Call 1/2 FAX  The status of the fax pass-through mode is displayed.

Call 1/2 Type  The direction of the call is displayed.

Call 1/2 Remote Hold  This indicates whether the far end has placed the call on hold.

Call 1/2 Callback  This indicates whether the call was triggered by a call back request.

Call 1/2 Peer Name  The name of the internal phone is displayed.

Call 1/2 Peer Phone  The phone number of the internal phone is displayed.

Call 1/2 Duration  The duration of the call is displayed.

Call 1/2 Packets Sent  The number of packets sent is displayed.

Call 1/2 Packets Recv  The number of packets received is displayed.

Call 1/2 Bytes Sent  The number of bytes sent is displayed.

Call 1/2 Bytes Recv  The number of bytes received is displayed.

Call 1/2 Decode Latency  The number of milliseconds for decoder latency is displayed.

Call 1/2 Jitter  The number of milliseconds for receiver jitter is displayed.

Call 1/2 Round Trip Delay  The number of milliseconds for delay is displayed.

Call 1/2 Packets Lost  The number of packets lost is displayed.

Call 1/2 Packet Error  The number of invalid packets received is displayed.

Call 1/2 Mapped RTP Port  The number of the NAT mapped RTP port is displayed.

Wireless-G Broadband Router with 2 Phone Ports

31

Page 32
Image 32
Linksys WRP400 manual System Status, Line 1/2 Status