Wireless-G Broadband Router with 2 Phone Ports

The Administration Tab - Factory Defaults

The Factory Defaults screen is protected by a password available only from your Internet phone service provider. Contact your provider for more information.

This screen is used to reset all the factory defaults. If you just want to reset the factory defaults for the Router, on the back of the Router, press the Reset Button for five seconds.

Figure 5-35: Administration Tab -

Factory Defaults

The Administration Tab - Firmware Upgrade

Upgrading the Router’s firmware requires a password available only from your Internet phone service provider.

Contact your provider for more information.

 

Figure 5-36: Administration Tab -

 

Firmware Upgrade

 

firmware: the programming code that

 

runs a networking device.

 

upgrade: to replace existing software or

 

firmware with a newer version.

48

Chapter 5: Configuring the Router

 

The Administration Tab - Factory Defaults

Page 56
Image 56
Linksys WRT54GP2 manual Administration Tab Factory Defaults, Administration Tab Firmware Upgrade, Runs a networking device