Wireless-G Broadband Router with RangeBooster
The Status Tab - Router
The Router screen on the Status Tab displays the Router’s current status.
Router Information
Firmware Version. This is the Router’s current firmware.
Current Time. This shows the time, as you set on the Setup Tab.
Internet MAC Address. This is the Router’s MAC Address, as seen by your ISP.
Host Name. If required by your ISP, this would have been entered on the Setup Tab.
Domain Name. If required by your ISP, this would have been entered on the Setup Tab.
Internet Connection
Connection Type. This indicates the type of Internet connection you are using. If your Router has a PPPoE Internet connection, the PPPoE IP Connection screen will be displayed, which allows you to disconnect the connection.
Internet IP Address. The Router’s Internet IP Address is displayed here.
Subnet Mask and Default Gateway. The Router’s Subnet Mask and Default Gateway address are displayed here for DHCP and static IP connections.
MTU. MTU is the Maximum Transmission Unit. It specifies the largest packet size permitted for Internet transmission. The default setting, Manual, allows you to enter the largest packet size that will be transmitted. You should leave this value in the 1200 to 1500 range. To have the Router select the best MTU for your Internet connection, select Auto.
IP Address Release. Available for a DHCP connection, click this button to release the current IP address of the device connected to the Router’s Internet port.
IP Address Renew. Available for a DHCP connection, click this button to replace the current IP
Chapter 6: Configuring the
Figure 5-47: Status Tab - Router
Figure 5-48: Status Tab - Router with PPPoE IP
Connection
36
The Status Tab - Router