Linn Kolektor owner manual Positioning the KOLEKTOR, Replacing the fuses

Replacing the fuses

The KOLEKTOR Preamplifier requires two fuses. To replace the fuses first identify the correct fuses for your local voltage; see Specifications, page 30, for the fuse ratings.

The fuse compartment is located below the mains inlet on the back panel. To replace the fuses pull open the compartment like a drawer, flip down the cover, and remove the two original fuses. Then insert the two replacement fuses, and close the fuse compartment.

WARNING: This appliance must be earthed. Use the earthed moulded mains lead supplied. Never use an unearthed plug or adaptor.

Positioning the KOLEKTOR

You can position your KOLEKTOR Preamplifier almost anywhere you find convenient, but the following considerations may be useful.

The KOLEKTOR Preamplifier can be placed on top of other Linn products, provided you allow plenty of air circulation around components that generate heat, such as power amplifiers.

If you are using the phono input you may need to keep the

KOLEKTOR up to 30cm away from a power amplifier.

Locating the KOLEKTOR for use with the handset

The Linn infra-red control system is exceptionally sensitive, and you should be able to operate your KOLEKTOR with the handset from almost anywhere in a room. For best results the infra-red sensor on

7