Manuals / Linn / Home Audio / Stereo Amplifier

Linn Kolektor owner manual Factory default settings, init, To reset the KOLEKTOR

Models: Kolektor

1 48

Page 36

Factory default settings

SWITCH ON	VOL+
POWER

""""

init

The KOLEKTOR Preamplifier provides a Reset to Factory Defaults option which allows you to reset the unit back to its factory settings. This restores the user options to their initial values, and resets the inputs to their initial source names.

To reset the KOLEKTOR

Switch off the KOLEKTOR, using the power switch on the front panel.

Press and hold down VOL+ (front panel) and switch on the power again.

Keep VOL+ held down until the display shows init.

The KOLEKTOR Preamplifier will then return to normal operation with the default settings, as shown underlined in the previous table.

Page 36

Image 36

Linn Kolektor owner manual Factory default settings, init, To reset the KOLEKTOR

Contents

LINN KOLEKTOR P R E A M P L I F I E R O W N E R S M A N U A LPage Important safety information MAINS PLUGSGENERAL SAFETY INSTRUCTIONS Mains plug replacement Replacing the fuseCE Declaration of Conformity FCC noticeDate of issue Date of issueContents MaintenanceIntroduction UnpackingSpecifications Technical informationIndex Copyright and acknowledgements viii Introduction L i n n K O L E K T O RWith the Linn KOLEKTOR you will hear the sources inYour Linn KOLEKTOR Audio moduleControl module Special features of the KOLEKTOR Independent source settingsInterface module Bass and treble controlsConfigurable source names Recording lockUser options Intelligent operation with other Linn productsUnpacking Setting up the KOLEKTORPositioning the KOLEKTOR Replacing the fusesLocating the KOLEKTOR for use with the handset Connecting the KOLEKTOR Connecting the sourcesConnecting a phono source Connecting a tape recorderConnecting to a power amplifier Connecting headphonesConnecting the mains supply suitable power outletUsing the KOLEKTOR Using the front paneltu 2 LOCK Using the handset LINNSwitching on and off To switch onSelecting a source Changing the volume To select a sourceTo select a source directly from the handset To change the volume Changing the balance~4 To mute the soundChanging the bass and treble 9~~9 To change the bass or trebleTo set up a recording To cancel a recordingRecording a source Configuring the inputs Using a moving magnet phono sourceCustomising the KOLEKTOR Removing inputsTo start configuring inputs To select the input to renameTo save the new input names Changing user options To change the user optionsTo choose a specific user option To save the user options User options initial value is shown underlinedRC5 Amplifier Factory default settings To reset the KOLEKTORinit Troubleshooting and maintenance TroubleshootingPoor response to handset commands There is no sound from the speakersMaintenance commandsCleaning Technical supportAmerica Specifications Technical informationGeneral Audiofactory default settings 26 front panel fuse replacementhandset headphones, connecting Linn Interconnect cables LOCK indicatorconnecting maintenanceMUTE indicator power amplifier, connectingvolume, changing unpacking user optionsuser options continued VOL- and VOL+ keys 12, voltage selectionPage Page Page Page LI N N PACK