Service Manual
1Service
General Operation
How the water heater operates
The Armor water heater uses an advanced stainless steel heat exchanger and an electronic control module that allows fully condensing operation. The blower pulls in gas and air and pushes flue products out of the water heater through the heat exchanger and flue piping. The control module regulates blower speed to control water heater firing rate. The gas valve senses the amount of air flowing into the water heater and allows only the right amount of gas to flow.
Sequence of operation
Table 1A shows control module normal sequences of operation for water heating operation.
Access modes
User
The user can adjust tank target temperatures by pressing the NAVIGATION dial when “$SETPOINTS” is flashing at the bottom of the display. The date and time, and the temperature units can also be changed.
Installer
Most parameters are available only to the installer, accessible by entering the installer password (5309).
Saving parameters (reference the Parameter Table -Table 1D on pages 12 and 13 of this manual)NOTICE
Please note that the brackets ([]) denote screen status.
To save parameters and exit programming:
Press the RIGHT SELECT [SAVE] key and then press the RIGHT SELECT [HOME] key.
To enter a parameter and continue programming:
Press the RIGHT SELECT [SAVE] key 1 time to return to the parameter listings; press again to return to the menu listings. Remember to press the RIGHT SELECT [HOME] key when finished programming in order to save the changes made.
8