PC Program Instructions
6Parameters
Parameter information screens
By accessing the Parameter Information Screens on the SMART TOUCH program, the installer can view all of the SMART TOUCH parameters. The installer can also change certain specific parameters to fine tune the operation of the boiler to the installation.
NOTE The PC cable must be connected to either the PC1 or PC2 connection. When connected, the status screen on the SYNC will show a communication error. This will clear automatically when the cable is removed.
To access the parameter list, click on the Parameters button along the top of the Main Screen window (FIG.
Adjustable parameters are located in:
Set 1: System Setup
Set 2: Functional Data
Set 4: Menu Values
While many parameters are viewable in each set, only select parameters are adjustable. To make an adjustment to a parameter, select the parameter to be changed from the appropriate set. Click on the box next to the parameter and type in the value for the parameter.
Figure 6-1 Parameters Pull-Down Menu Screen
Once an adjustment has been made to a parameter, it must be programmed into the SMART TOUCH. On the Parameter pull down menu, click on the Program Parameters into Control button. This will bring up another pull down menu. If a parameter was changed in just one set, select the set from the menu and click on it. If changes were made in multiple sets, select the Store Parameter Set
While the programming is taking place, the SMART TOUCH will go into a lockout mode. It will require that the Reset button on the display be pressed after the programming has been completed before the unit will be allowed to operate.
10