INS7162 Rev-
TM
INSTALLATION INSTRUCTIONS
INTRODUCTION
The MP2is capable of controlling the supply water tempera- ture for up to nine ON / OFF stages based on outdoor tem- perature, control for the Domestic Hot Water (DHW) gener- ation, a set point requirement or optionally an external input signal (0 - 10 V (dc)). A large easy to read display provides current system temperatures and operating status (FIG. 1). The control has outputs for a primary pump and a combus- tion air damper or alarm. Based on the mode of operation selected, the control can operate different combinations of boiler stages and boiler pumps.
ADDITIONAL FUNCTIONS INCLUDE:
•Installer and Advanced Access Levels
•Primary Pump Output
•Individual Boiler Pump Outputs (in applicable modes)
•Pump Exercising
•Pump Purging (primary and boiler)
•Boiler Demand for Space Heating Loads
•DHW Demand for DHW Loads
•Set Point Demand for Set Point Loads
•Test Sequence to Ensure Proper Component Operation
•Setback Input for Energy Savings
•0 - 10 V (dc) Input Signal
Modes
1Up to 9 On/Off Boilers
2Up to 4 On/Off Boilers & 4 Pumps
3 Up to 4 Lo/Hi Boilers
4Up to 3 Lo/Hi Boilers & 3 Pumps
5Up to 3 Three Stage Boilers
6 Up to 2 Three Stage Boilers & 2 Pumps 
7 Up to 2 Four Stage Boilers
8 1 Four Stage Boiler & 1 Pump 
FIG. 1
