Optional Equipment | 37 |
Stove Leg Installation (Brass # 99200500, Cast Black # 99200800, Black Steel # 99200100)
Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Attach each leg to the stove by inserting a bolt and washer through the hole or slot in the leg and into the threaded hole on the stove.
9/16" Socket Wrench
These
Pedestal (Part # 99200106)
IIf using outside air with the pedestal, follow the directions below under "Using Outside Air with the Pedestal" prior to installing the pedestal.
Use a 9/16" wrench to attach the two pedestal bolts to the bottom of the stove.
Stove
The lag bolts and washers
may be inserted through the holes in the base of the
9/16" Socket Wrench | pedestal to |
| anchor the |
pedestal to the floor.
The screen, insulation, cover plate, and staples are used for outside air.
Pedestal
NOTE: when attached, the stove front is flush with the
Using Outside Air with the Pedestal
Before installing, check the section "Outside Air Requirements" on page 11 for installation concerns.
1.Determine the location of the outside air hole penetrating the floor (& hearth). The illustration above details the size of pedestal and its location in relation to the stove. The hole may be cut anywhere underneath the pedestal, as long as it is not within 2" of the outside perimeter of the pedestal, is at least 16 square inches in area, and does not interfere with structural members of the home. Place the rodent screen over the hole (above or below) and secure with staples.
Travis Industries | 93508131 | 4 020327 |
