42 | Optional Equipment |
3.Place the insert into the fireplace and connect the flue (if using a positive or direct connection). Install the top panel and trim following the directions below.
Top Trim
Top
Panel
a
Install the top panel so the two tabs insert into the joggle clips on the top panel.
"L" Bracket
Right
Side
Trim
Tape
Tighten the set screws from the b back side with a small standard
screwdriver
Top Trim
"L" Bracket
Right Side
Trim
Construct the panel trim. Insert one leg of each "L" bracket into the top and side trim piece. Align the trim to form a precise corner, then tighten the two set screws with a small standard screwdriver. Slide the trim over the panels. Attach a piece of included double- back tape to the bottom of each side trim to keep it from flaring at the bottom.
Insulation Installation (required for face seal installations only)
1.With the insert drawn 6" from the fireplace, glue the insulation strip included with the surround panel kit to the back of the panels using RTV silicon or stove gasket cement. The insulation should be installed so it overlaps the fireplace opening to form a seal between the panels and the fireplace face. Let the silicon or cement dry.
2.Push the insert into the fireplace, allowing the insulation to form a seal between the panels and the fireplace. Use a screwdriver to tuck any exposed insulation behind the panels.
Travis Industries | 93508131 | 4 020327 |
