Outside Air Boot Installation (Part number 99200134)

40

Optional Equipment

Outside Air Boot Installation (Part number 99200134)

The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air Requirements" on page Error! Bookmark not defined. for installation concerns. The directions below detail installation.

1 Install the cover plate following the directions below (use the cover plate that is 6-1/2" wide).

Remove the two screws on the cover plate to remove the piece that fits over the air control rod. Then replace the piece when the cover plate is in place.

Air Control Rod

The cover plate has a clip which attaches it underneath the air control.

2Refer to the illustration on the following page to determine the location and size of the hole penetrating the floor and. Cut the hole prior to locating the stove.

3Attach gasket to the bottom edge of the lower air boot section (near the screen). Attach gasket on top of the flanges on the upper air boot section. Slide the two sections together with both seams facing the rear (do not attach the two sections at this time).

4Follow the directions below for attaching the upper section of the air boot (with gasket) to the stove.

5Slide the lower section down until it contacts the hearth. Attach the two sections together following the directions below

 

 

Use a

Bottom of Stove

 

screwdriver to

 

 

 

 

pry out the

Attach the included

 

knock-out.

gasket to all four top

 

 

 

edges of the air boot.

 

 

 

 

 

Attach the air boot with

 

 

the two screws included

 

 

with the kit.

 

 

 

 

1/4" Nutdriver

 

 

Use the included screws to attach

 

 

the two telescoping portions of air

 

 

boot together. The included drill bit

 

5-1/8”

should be used to drill the hole.

 

 

8-7/8”

 

Make sure the air boot is expanded

 

to the correct size before drilling.

Attach gasket to the bottom

 

 

 

 

edge of the air boot.

 

 

 

 

 

9/64” Drill Bit

5/16" Nutdriver

 

 

The hole in the floor (and hearth)

 

 

must be a minimum 16 square

 

 

inches. It should be 1/2” smaller

 

 

than the footprint of the air boot in

Floor (and hearth)

 

each dimension to allow for the

 

 

gasket to seal.

Travis Industries

93508131

4 020327

Page 40
Image 40
Lopi Answer Wood Stove owner manual Optional Equipment, Outside Air Boot Installation Part number