STANDING PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instruc- tions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been
under water. | PN 91217 02/05 |
LIGHTING INSTRUCTIONS 
1.STOP! Read the information on the safety label.
2.Set thermostat to lowest setting.
3.Turn off all electric power to the appliance.
4.Remove lower front panel.
5.Push in gas control knob slightly and and turn
clockwise 
to “OFF”.
Gas Control Knob
NOTE: Knob can not be turned from “PILOT” to “OFF” unless knob is pushed in slightly.
Do not force.
Pilot Control Knob
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the information on the safety label. If you don’t smell gas, go to the next step.
7.Locate red piezo ignitor button. Locate pilot. (Follow metal pilot tube from gas control).
8.Turn gas control knob counterclockwise 
to “PILOT”.
9.Push in pilot control knob and hold in. Immediately begin a series of pushing and releasing the red piezo ignitor button, while observing the pilot. Continue to spark until pilot is lit. Continue to hold the pilot control knob in for about one (1) minute after the pilot is lit. Release the pilot control knob and it will pop back up. Pilot should remain lit. If pilot goes out, repeat steps 5 thru 9.
•If knob does not pop up when released, STOP and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
10.Turn gas control knob counterclockwise 
to “ON”.
11.Replace lower front panel.
12.Turn on all electric to the appliance.
13.Set thermostat to desired setting.
PN 91217 02/05
TO TURN OFF GAS TO APPLIANCE
1. | Turn thermostat to lowest setting. | 4. | Push in gas control knob slightly and turn clockwise | |
| to “OFF”. Do not force. | |||
2. | Turn off all electric power to the appliance if service is |
| ||
5. | Replace lower front panel. | |||
| to be performed. | |||
|
| PN 91217 02/05 | ||
3. | Remove lower front panel. |
| ||
|
|
Page 10
