METAL
NUT WASHER
RUBBER
WASHERS
3.Once you determine the correct position for the ratchets, assemble the transducer as shown at left. Do not tighten the lock
nut at this time.
METAL
WASHER
BOLT
4.Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground.The bottom of the transducer bracket should be in line with the bottom of the hull. Don't let the bracket extend below the hull! Mark the center of the slots for the mounting holes. Drill two 5/32" holes in the marked locations for the #10 screws supplied with the transducer.
TRANSOM
SIDE VIEW
5.Attach the transducer to the transom. Slide the transducer up or down until it’s aligned properly on the transom as shown above. Tighten the bracket’s mounting screws. Adjust the transducer so that it’s parallel to the ground and tighten the lock nut until it touches the flat washer, then add 1/4 turn. Don’t over tighten the lock nut! If you do, the transducer won’t
4
