Lowrance electronic X51 manual Installation Preparations, Transducer Installation

Section 1: Installation

Thank you for buying a Lowrance® sonar! Your unit is a high quality sonar designed for both professional and novice fishermen. All Lowrance sonars have an automatic mode that finds and displays the bottom, fish, underwater structure and more – right out of the box. All you have to do is press the on (PWR) key.

NOTICE!

The storage and operation temperature range for your unit is from -4 degrees to +167 degrees Fahrenheit (-20 degrees to +75 degrees Celsius). Extended storage or operation in temperatures higher or lower than specified will damage the liquid crystal display in your unit. This type of damage is not covered by the warranty. For more information, contact the factory's Customer Service Department; phone numbers are inside the manual's back cover.

Installation Preparations

You can install the sonar system in some other order if you prefer, but we recommend this installation sequence:

Caution:

You should read over this entire installation section before drilling any holes in your vessel!

1.Determine the approximate location for the sonar unit, so you can plan how and where to route the cables for the transducer and power. This will help you make sure you have enough cable length for the desired configuration.

2.Determine the approximate location for the transducer and its cable route.

3.Determine the location of your battery or other power connection, along with the power cable route.

4.Install the transducer and route the transducer cable to the sonar unit.

5.Install the power cable and route it to the sonar unit.

6.Mount the sonar unit.

Transducer Installation

These instructions will help you install your Skimmer® transducer on a transom, on a trolling motor or inside a hull. Read these instructions carefully before attempting the installation. Determine which of the

3