Installation 3
UPS with Bypass Module Startup
o start up the :
ake sure the Bypass switch on the Bypass odule rear panel is in the
A position (see igure5 on page 26 or igure6 on page 27).
f your Bypass odule is a hardwired unit, supply utility power.
f your Bypass odule is a plug/receptacle unit, plug the input power cord into the utility input connector on the Bypass odule rear panel.
lug the other end of the power cord into a grounded, three2wire, AC receptacle that has been wired in accordance with C specifications or national wiring rules. (ee igure11 for an example.)
Phase 1 |
|
|
| 200/208/220/230/240V | L |
| N | |
Phase 2/Neutral |
| |
| G | |
(International) |
| Ground |
Figure 11. L6#30 Receptacle
iNOTE Steps 4 through 7 are for changing the output voltage. The output voltage is factory&configured for 230V. If you do not need to change the output voltage, skip to Step8. Use the following table to select the correct output voltage according to your Bypass Module.
Bypass Module Model Number | UPS Voltage Selection* |
|
|
604Hz BDM 208: 120/208 | 208 |
|
|
604Hz BDM 208: 120/240 | 208 |
|
|
604Hz BDM 208: 120 | 208 |
|
|
604Hz BDM 240: 120/240 | Set to 220V for 110/220V BDM output |
| Set to 230V for 115/230V BDM output |
| Set to 240V for 120/240V BDM output |
|
|
604Hz BDM 240: 120 | Set to 220V for 110V BDM output |
| Set to 230V for 115V BDM output |
| Set to 240V for 120V BDM output |
|
|
504Hz BIM 208 Model 2500 only | 208 |
|
|
504Hz BIM 220 | 220 |
|
|
504Hz BIM 230 | 230 |
|
|
504Hz BIM 240 | 240 |
|
|
*The UPS output voltage should be set according to local mains voltage.
Lucent Technologies Model 3000 UPS Operators Manual 16744054119 Issue 3 | 33 |
