Lucent Technologies 555-230-796 manual Setting the COM Port Baud Rate

Programming

In this situation, the Remote Module tries to reconnect with the Switch Module a maximum of six times. If the connection with the Switch Module is not re-established after the sixth try, the modem disconnects and you must log in again.

4.To view the next Connect Rate, press 3; to view the previous Connect Rate, press 1. Press 2 to accept the Connect Rate displayed.

Setting the COM Port Baud Rate

You must set the baud rate for the COM 1 port on the Remote Module. This is the rate at which data will be transmitted to and from your remote terminal device, usually a computer. Two rates are available: 19.2 kbps and 9.6 kbps. Follow these steps to set the rate for the COM 1 port:

1.At the “Go Online?” screen, press 3 until the following screen appears:

2.Press 2 to get the Comm Port rate. If 9600 kbps is in effect, the following screen appears:

3. Press 2 to change the setting or 1 to retain the existing setting.

3-8Issue 2 July 1997