Mackie CR1604 - VLZ owner manual UL Warning, Mackie Disclaimer, About Jumpers

BEFORE

AFTER

MODIFICATIONS

UL Warning

CAUTION! These modi-

fication instructions are

for use by qualified per- sonnel only. To avoid

electric shock, do not perform any servicing other than changing the fuse unless you are qualified to do so. Refer all servicing and modifying to qualified personnel.

Mackie Disclaimer

Any modification of any Mackie Designs prod- uct must be performed by a competent electronic technician. Mackie Designs accepts no responsi- bility for any damages or injuries caused by any modification, regardless of the source of the modi- fication instructions or the qualifications of the technician performing them. In the case of such damages, Mackie Designs may declare warranty privileges void. BE CAREFUL!

About Jumpers

We recommend solid (non-stranded) wire, 26–28 gauge (wire-wrapping variety). When in- stalling jumpers, do not run their ends through holes in the circuit board. Rather, solder them flat against the desired pad (the flat silver area, possi- bly with a hole in the middle). Make sure the ends of these flat wires do not extend beyond the pad.

Jumper

Holes	Ch. 16	Ch. 15
Solder

cut

here

5

6

jumpers

here

CR1604-VLZ Post-EQ Mod

This changes AUX SENDS 1 and 2, with the pre switch engaged, to receive their signals post-EQinstead of pre-EQ. The signal remains post-low cut, pre-mute and pre-fader. With the pre switch disen- gaged (up), the signals are not affected by the mod. The following must be performed for each channel you wish to modify:

1.Remove all cords, including the power cable, from the CR1604-VLZ.

2.Place the mixer upside-down on a dry, non- marring surface.

3.If you have converted your mixer to the rack- mount position or have installed a RotoPod, undo those changes and temporarily configure the mixer in the original desktop mode. You do not have to install the pod, just get it out of the way of the bottom cover.

4.Remove the screws that attach the bottom cover. Keep track of what screws go where. Remove the bottom cover.

5.Cut the conductor at point C, between the square and round pads. Be careful to cut all the way through the conductor, and do no cut any nearby traces. Each channel is slightly different, but this graphic shows Channel 16, which is very different from the others, and Channel 15 (respectively), which is similiar to the remaining channels.

6.Add a jumper from the square pad at point B to the square pad at point C.

7.Repeat for each channel you wish to modify.

8.Check your work very carefully, them put the bottom cover back the way you found it. You’re done!

28