Configuration
Before starting a Project, you will need to configure the SDR24/96 I/O options and synchronization parameters. These parameters determine where the input signal is coming from, where the sample clock is coming from, how fast the sample clock runs, and how many bits are recorded in every sample. Some options, like sample rate and bit depth, will become “standards” that you won’t need to change very often. Others, like
Operation
Note: When 88.2 kHz or 96 kHz sampling rate is selected (X2 mode), each digital optical port carries only 4 tracks instead of 8, due to a limitation in the ADAT Optical specifica- tion. Tracks
Track I/O Setup
By default, each of the physical inputs and outputs on the SDR24/96 corresponds to their track numbers when recording and playing back audio. You can customize the inputs and outputs to go to any of the tracks using the TRACK INPUT SELECT and TRACK OUTPUT SELECT menus. These settings apply to both the analog and digital inputs and outputs, and are saved with the project file.
To configure the track input mapping: |
|
| SETUP | |
|
|
| ||
SETUP MENU | > | |||
1. Press SETUP to enter the | ||||
Record I/O | Sync Transp | |||
SETUP MENU. | ||||
|
|
|
2. Select I/O to enter the TRACK
INPUT SELECT menu.TRACK INPUT SELECT > TRK:3. Select |
|
| |
shows you the current setting |
|
| |
TRK 1- 8 INP: Direct | |||
for inputs | |||
Custom. | Direct | Custom Exit |
4.Select Direct for direct
5.Select Custom to route inputs to different track numbers.
♦You can assign an input to more than one track.
♦If an input is routed to an alternate track (i.e., Input 1 to Track 9), the Input Type assignment doesn’t change (see “Input Type Setup” on the next page).
6. Press the Inc (increment) and |
| Track | New | Current | |||
| Setting | Setting | |||||
Dec (decrement) select buttons |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
to change the input number | TRK | 1 INP: 1 ( 1) > | |||||
that is assigned to Track 1. | Inc | Dec | Apply | Exit | |||
Select Apply to save the change. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Guide
7.Press the Page Right button to scroll to the next track. Repeat step 6 for Track 2, and so on.
8.Select Exit when finished with Tracks
menu. Press the Page Left button to return to the TRACK INPUT SELECT menu to edit tracks
9.Select Exit when finished to exit.
To configure the track output mapping:
1.Press SETUP to enter the
SETUP MENU.
2.Select I/O. Press the Page
Right button to enter the TRACK OUTPUT SELECT menu.
SETUP MENU | > |
|
| ||
Record | I/O | Sync Transp |
| ||
|
|
|
| ||
< TRACK OUTPUT SELECT | > |
|
| ||
TRK: |
|
| |||
|
|
|
|
|
|
|
| Operation Guide |
|
| 17 |
|
|
|
|
|
|