Mackie SDR24, SDR96 Input Type Setup, TRK, Inc, Dec, INP, Exit, Apply, Direct, Custom Exit, 1 TYPE: ADAT, 1 OUT: 1 ( 1), INP: 1-8 9-16, Analog ADAT Exit,

INP 1- 8 TYPE: ADAT Analog ADAT Custom Exit

SDR 24/96

Note: The front panel display’s back- light switches off after ten minutes of inactivity. You can revive it at any time by pressing either the Page Left [<] or Page Right [>] but- ton, or any Select button below the display.

3. Select 1-8. The LCD display
3. Select 1-8. The LCD display	TRK 1- 8 OUT: Direct
shows you the current setting for	TRK 1- 8 OUT: Direct
outputs 1-8, either Direct or	Direct	Custom Exit

Custom.

4.Select Direct for direct track-to-output playback (i.e., Track 1 to Output 1, Track 2 to Output 2, etc.).

5.Select Custom to route tracks to different output numbers.

6. Press the Inc (increment) and		Track	New	Current
6. Press the Inc (increment) and		Track	Setting	Setting
Dec (decrement) buttons to
Dec (decrement) buttons to
change the output number that is	TRK	1 OUT: 1 ( 1) >
assigned to Track 1. Select Apply	Inc	Dec	Apply	Exit
to save the change.
to save the change.

7.Press the Page Right button to scroll to the next track. Repeat step 6 for Track 2, and so on.

8.Select Exit when finished with Tracks 1-8 to return to the previous menu.

Press the Page Left button to return to the TRACK OUTPUT SELECT menu to edit tracks 9-16 and 17-24.

9.Press the SETUP button when done.

Notes:

♦You cannot route a track to more than one output.

♦You cannot assign more than one track to a single output. Attempting to do so will cause the output assignments to switch places for the two tracks.

Input Type Setup

The SDR24/96 can read only one input for each track, either analog or digital. This must be configured in the Setup menu. Since these settings depend on how the SDR is connected to the console, these are global settings, and are project independent.

To configure the input type format:

1.Press SETUP to enter the

SETUP MENU.

SETUPMENU> Record I/O SyncTransp

2.	Select I/O.
3.	Press the Page Right button
3.	Press the Page Right button	< INPUT TYPE SELECT
	two times to enter the INPUT	< INPUT TYPE SELECT
	TYPE SELECT menu.	INP: 1-8 9-16 17-24

4. Select 1-8. The LCD display shows you the current input settings for the 8 inputs selected. Select Analog when using the

DB25 Analog inputs, and ADAT when using the Digital optical inputs.

5.	The SDR24/96 also provides the
5.	The SDR24/96 also provides the	INP	1 TYPE: ADAT	>
	option of customizing each input	INP	1 TYPE: ADAT	>
	individually for either analog or		Analog ADAT Exit
	digital formats. Select the Custom
	button and use the Page Left and Page Right		buttons to scroll
	through the 8 inputs. Choose either analog or digital for each input.
6.	Repeat steps 4 and 5 for inputs 9-16 and 17-24.

18 SDR24/96