INITIAL SETTING
These operations are accessible by remote control. Some may also be accessible by controls on the main TV.
5Initial Setup
This section will guide you through the TV’s initial setting which includes selecting a language for your
Before you begin:
Make sure if the TV is connected to antenna or cables.
1After making all the necessary connections, press [POWER y] to turn on the TV.
• This operation may take a few moments.
2Use [Cursor K/L] to select the
InitialI iti l Setupt
|
|
|
|
|
| Select the language for setup display. | English |
| |
|
|
|
|
|
| Elija el idioma de ajuste. | Español |
| |
|
|
|
|
|
| Sélectionner langue écran config. |
|
| |
| Français |
| ||
|
|
|
|
|
Note:
•If you connect the cable system directly, contact the CATV installer.
•If you press [POWER y] or [MENU] during autoprogram, this setting will be canceled.
•The initial autoprogram function can be executed for either “Air” or “Cable” only once. When you change the connection (Air/Cable), set autoprogram again. (Refer to page 15.)
•You can cancel or exit the initial autoprogram menu by pressing [MENU].
•If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the TV, “Helpful Hints” appears. Follow the instructions listed on the TV screen.
No channel is registered.
Press and hold "OK" key on the remote control for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Pulse durante 3 segundos la tecla "OK" en el control remoto.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Enfoncez "OK" 3 secondes sur la télécommande.
Contacter numero d'urgence dans manuel ou arrière appareil.
Select | OK OK | MENU |
Exit |
•“Initial Setup” menu on step 3 will be displayed in the selected language after you press [OK].
3Use [Cursor K/L] to select “Air” for TV channels or “Cable” for CATV channels, then press [OK].
InitialI iti l Setupt
Make sure the antenna is connected to "ANT.IN" jack. Select your signal source.
Air
CableOr
ANT.IN
Air
Cable
Select | OK OK | BACK | MENU |
Back | Exit |
•Scanning and memorizing of channels start automatically.
InitialI iti l Setupt
Now the system is scanning for channels, please wait.
2%
Analog channels
0 ch
Digital channels
0 ch
MENU
Exit
•When the scanning and memorizing of channels are completed, the lowest memorized channel will be displayed.
14
EN
A8AF2UH_32MF338 B_EN_v2.indd 14
2008/02/15 14:52:27
