Magnavox MDR513H / F7 owner manual Setting the Clock, Auto Clock Setting

3

below.

1

2

Select “Manual” at step 4 above, then press [OK].

Use [the Number buttons] or [K/ L] to enter your Cable TV Analog PBS channel number, then press [OK].

Set Channel No.

Manual Auto Clock Setting

If the unit chooses an incorrect PBS channel on Cable TV, set the PBS channel manually by following the steps

5 Press [SETUP] to exit.

SETTING THE CLOCK

Auto Clock Setting

This unit can set the time and date automatically by				ANALOG AUTO CLOCK SETTING (Cable TV only)
referring to a channel that carries a clock information. If a
PBS (public broadcasting station) is available on Cable in					Press [SETUP] and use [K/ L] to
your area, follow “Auto Clock Setting” below. If not, follow					select “General Setting”, then press
“Manual Clock Setting” on page 34.
				1 [OK].
Make sure
• The cable TV connections are correct.				2	“General Setting” menu will appear.
• Channels are set. (Refer to page 29.)					Use [K/ L] to select “Clock”, then
					press [OK].
					“Clock” menu will appear.
STANDBY-ON			OPEN/
	DTV/TV	SOURCE	CLOSE		Use [K/ L] to select “Auto Clock
				3
.@/:	ABC	DEF			Setting”, then press [OK].
GHI	JKL	MNO	CHANNEL		Use [K/ L] to select “Auto”, then
PQRS	TUV	WXYZ		4 pressAuto Clock[OK].Setting
	SPACE	CLEAR
SETUP	AUDIO	REPEAT	HDMI		OFF
					Auto
					Manual
DISC MENU			TITLE

OK

DISPLAYRETURN

			Press [STANDBY-ON y] to turn the
V.REPLAY	V.SKIP		unit to the standby mode.
			This unit will search for the time only when the
			6 power is in the standby mode. Initially leave it in
			standby mode for at least 15 minutes to give this
RAPID PLAY			unit time to set the clock. Once the clock is set, the
			unit receives the clock data at 12:00 am & 12:00 pm
D.DUBBING	HDD	DVD	when unit is in standby mode. Check the time after
			the Auto Clock was set, if it is incorrect time then set
TIMER	REC MODE	REC	the “Auto Clock Setting“ to “OFF” in step 4 above.
			Then try “Manual Clock Setting“ on page 34.

Note

•The clock may set itself automatically after you connect the antenna/cable signal and plug in the power cord.

•Only the Analog PBS channel Cable TV signal is effective for auto clock setting.

•For analog auto clock setting, incorrect time may be obtained depending on the broadcast information. If this occurs, set the “Auto Clock Setting” to “OFF” at step 4 above and try “Manual Clock Setting” on page 34.

CH 1

Press [SETUP] to exit and turn the unit to the standby mode.

32 EN