Replacing the saw chain
CAUTION:
Use only chains and guide bars designed for this saw (see the Extract from the
Check the sprocket (7) before mounting a new chain.
The sprocket is located underneath the clutch drum (8).
CAUTION:
Worn out sprockets (9) may damage the new chain and must therefore be replaced.
Do not attempt to replace the sprocket yourself. Sprocket replacement requires special training and tools and must be done at a MAKITA service centre.
7
8
9
Replacing the suction head
The felt filter (10) of the suction head can become clogged. It is recommended to replace the suction head once every three months in order to ensure unimpeded fuel flow to the carbure- tor.
To remove the suction head for replacement, pull it out through the tank filler neck using a piece of wire bent at one end to form a hook.
10 
C
D
Cleaning the air filter STOP
Unscrew screw (11) and remove the filter cover (12).
IMPORTANT: Cover the intake opening with a clean cloth in order to prevent dirt particles from falling into the carburetor.
Remove the filter (13) with foam insert (14).
CAUTION: To prevent injury to the eyes, do NOT blow out dirt particles! Do not use fuel to clean the air filter.
Clean the air filter with a soft brush.
If the filter is very dirty, clean it in lukewarm water with dishwashing detergent.
Let the air filter dry completely.
Put the filter and insert back together.
If the filter is very dirty, clean it frequently (several times a day), because only a clean air filter provides full engine power.
CAUTION:
Replace damaged air filters immediately.
Pieces of cloth or large dirt particles can destroy the engine!
11 12
13 
14 
E
29
