Makita DPC 7000, DPC 9501, DPC 9500 Trouble shootig, Defective, Valve dirty DPC 7001, DPC

Guarantee

MAKITA guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resultingfrom material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular guarantee conditions may exist. If you have any questions, please contact your salesman, who is responsible for the guarantee of the product.

Please note that we cannot accept any responsibility for damage caused by:

Disregard of the owner’s manual.

Non-performance of the required maintenance and cleaning.

Incorrect carburetor adjustment.

Normal wear and tear.

Obvious overloading due to permanent exceeding of the upper performance limits.

The use of other than original MAKITA cutting discs.

Use of force, improper use, misuse or accidents.

Damage from overheating due to dirt on the fan housing.

Work on the Power Cut by unskilled persons or inappropriate repairs.

Use of unsuitable spare parts or parts which are not original MAKITA parts, insofar as they have caused the damage.

Use of unsuitable or old oil.

Damage related to conditions arising from lease or rent contracts.

Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed by a MAKITA service centre.

Trouble shootig

Malfunction	System	0bservation	Cause
Cutting disc does not	Clutch	Engine runs	Damage to clutch
start turning
Engine does not start	Ignition system	Ignition spark	Malfunction in fuel supply system, com-
only with difficulty			pression system, mechanical malfunction.
		No ignition spark	Switch on STOP, fault or short-circuit in the
			wiring, plug cap or spark plug defective.
	Fuel supply	Fuel tank is filled	Choke in wrong position, carburetor defective,
			suction head dirty, fuel line bent or interrupted.
	Compression	Inside	Cylinder base packing ring defective, radial
	system		shaft packings defective, cylinder or piston rings
			defective
		Outside	Spark plug does not seal.
	Mechanical	Starter does not engage	Spring in starter broken, broken parts
	malfunction		inside the engine.
	~
Warm start difficulties	Carburetor	Fuel tank is filled	Wrong carburetor adjustment.
		Ignition spark
Engine starts, but	Fuel supply	Fuel tank is filled	Wrong idling adjustment, suction heador
dies immediately			carburetor dirty.
			Tank venting defective, fuel line interrupted,
			cable defective, STOP switch defective. Starting
			valve dirty (DPC 7001, DPC 9501).
Insufficient power	Severalsystems	Engine is idling	Air filter dirty, wrong carburetor adjustment,
	may be involved		Tuffler clogged, exhaust channel in cylinder
	simultaneously		:logged.

24