P 14/16
Wiring diagram
Fig. D-2
HS6100 & HS7100
(without Electric brake and LED light)
Be careful not to put Lead wire (blue or white) of Power supply cord on Noise suppressor after connecting it to Terminal block.
Route Field lead wires into Handle section through this groove.
Field lead wires must be tight in Motor housing.
Switch
Be careful not to put Lead wires on the boss and ribs A, B, C, D.
rib C rib D
Strain relief 
rib A |
|
Noise suppressor | rib B |
(if used) |
|
boss
Terminal block
Field
Fix Field lead wires in these Lead wire holders.
If Noise suppressor is used, route Noise suppressor’s lead wires between rib A and rib B. Be careful not to put them on Noise suppressor, ribs A and B.
Set Terminal block in Handle section with each terminal positioned as follows: *On Strain relief side, the terminal with which
the Lead wire of Power supply cord is connected must be positioned.
*On Field side, the terminal with which the Field lead wire is connected must be positioned.
Field lead wires must be tight in Motor housing.
