P 11/16
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Handle Cover, Electrical Parts in Handle
DISASSEMBLING
Remove Handle cover from Motor housing as described in Fig. 14.
Note: No need to disassemble Blade case or Motor housing.
Fig. 14
1. Lift up Handle cover |
|
| 2. Turn Handle cover |
|
| 3. Electrical parts (Switch, Power supply cord, |
in the direction of arrow | . |
| in the direction of arrow | . |
| LED light circuit, Controller etc.) can now |
|
|
| Then pull the Handle cover |
|
| be replaced. |
|
|
| in the direction of arrow | . |
|
|
Power supply cord
Switch
LED light circuit
[4] ADJUSTMENT
[4]-1 Angle of Saw Blade to Base
(1)Attach Saw blade to the unplugged machine, and set to the cutting depth to maximum.
(2)Adjust the angle of saw blade to Base as described in Fig. 15.
Fig. 15
[Adjustment to 90 degrees] | [Adjustment to 45 degrees] |
1.Set the cutting depth of the machine to maximum with the bevel angle adjusted to 90 degrees.
2.Tighten Lever 45, Lever 70 and M6 Thumb nut.
3.Open Safety cover fully, then apply 1R208 to the base metal of the saw blade as drawn below, Then adjust for 90 degree accuracy by turning M6x8 Hex socket set screw with hex wrench.
1.Set the cutting depth of the machine to maximum with the bevel angle adjusted to 45 degrees.
2.Tighten Lever 45, Lever 70 and M6 Thumb nut.
3.Open Safety cover fully, then apply 1R207 to the base metal of the saw blade as drawn below, Then adjust for 45 degree accuracy by turning M6x8 Hex socket set screw with hex wrench.
1R208 | 1R207 |
