![](/images/new-backgrounds/1311068/31106815x1.webp)
P 8/16
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Blade Case, Blade Cover, Safety Cover
DISASSEMBLING
(1)Separate Motor housing and Armature from Blade case section as described in Fig. 7.
Fig. 7
1. Remove Carbon brush. |
| 2. Remove three M5x45 Pan head screws. |
Brush holder |
| Brush holder |
|
cap | Carbon brush | cap |
|
|
|
| |
3. Separate Motor housing from Blade case section. | 4. Remove Armature together with Shaft lock |
and Compression spring 7.
Compression spring 7
Armature
Rubber washer 13
Shaft lock
Note:
If Rubber washer 13 falls off Motor housing in this step, put it back into Bearing box of Motor housing.
(2)Remove both Angular guide section and Rear angular guide section from Base. (Fig. 2)
(3)Remove Depth guide and M6x8 Hex bolt from Blade case. (Fig. 4)
(4)Remove Safety cover together with Tension spring 4, Bearing box and other parts from Blade case. (Fig. 8)
Fig. 8
| M5x8 Hex socket |
|
Tension spring 4 | set screw |
|
Bearing box |
| |
|
| |
Safety cover | M5x16 | O Ring 44 |
| Pan head screw |
|
Retaining ring |
| Rubber sleeve 6 |
| M6x20 Pan head screw | |
Use 1R003 for removing Retaining ring |
| |
|
|