Makita LF1000 dimensions When installing Sleeve 13 and Connecting rod on Knob, 7mm, Rib

P 10/ 30

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-5. Blade Case Section (cont.)

ASSEMBLING

Do the reverse step of disassembling steps. Remember the following notes.

1. When installing Sleeve 13 and Connecting rod on Knob 40;

Slide Sleeve 13 as far as possible toward Steel ball 6. At this time, the distance between Sleeve 13 and the neck of Knob 40 will be about 7mm. While keeping the distance, secure Connecting rod to Sleeve 13 with Hex socket head bolt M6x30. (Fig. 23)

Fig. 23

7mm	Hex socket head
	bolt M6x30
Knob 40	Flat washer 6
Sleeve 13	Sleeve 6
	Connecting rod
Steel ball 6
on Knob 40
Adjust nut

2. When installing Link plate and Safety cover on Blade case;

As illustrated in Fig. 24, put Link plate on Ball bearing 608LLB that is mounted to the inside wall of Blade case for smooth action of Link plate. Then secure Link plate to Arm complete with Hex socket head bolt M6x20. (Fig. 20) On the back of Safety cover, there is a rib that acts as a guide rail for the Ball bearing on Link plate.

Mount Safety cover to Bearing box so that the Ball bearing of Link plate fits on the rib. (Fig. 25) And secure Safety cover with Retaining ring S-42. (Fig. 14)

Fig. 24

Blade case

Link plate

Ball bearing 608LLB

Ball bearing (integral part of Link plate)

Fig. 25

Tension spring 4
Safety cover
Rib
Safety cover and Link plate correctly set in place,
viewed from the Motor housing side
Blade case
Link plate
Ball bearing
of Link plate	Tension spring 4
Rib	Safety cover