CONNECTIONS
CONNECTING SPEAKERS
FRONT SPEAKER | POWERED |
Before you connect your speakers, read the following:
• Disconnect the mains cord from the wall outlet. |
• Read the instructions supplied with your |
speakers. |
• Pay close attention to speaker wiring polarity. In |
other words, connect positive ª terminals only |
to positive ª terminals, and negative · |
terminals only to negative · terminals. If you |
get them the wrong way around, the sound will |
7Connecting a subwoofer
Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (the power amplifier is built in ). If your subwoofer is a passive type (the power amplifier is not built in), connect a monaural power amplifier to the PRE OUT SUBWOOFER jack and connect the subwoofer to the amplifier.
ENGLISH
RIGHT |
LEFT | SUBWOOFER |
be out of phase and will sound odd. |
• Only use speakers with an impedance of 6 ohms |
or higher. If you use speakers with a lower |
impedance, and use the amplifier at high volume |
levels for a long period of time, the |
protection circuit may be activated. |
• Unnecessarily long or very thin speaker wires |
may affect the sound quality and should be |
avoided. |
• Be careful not to short the positive and negative |
connections. Doing so may damage the CR601. |
1. | Strip away approx. 10 |
| |
| mm (3/8 inch) of wire |
| |
| insulation. | 10 mm (3/8 inch) | |
2. | Twist | the |
|
| bared | wire |
|
ends tight, to prevent short circuits.
3.Push the terminal lever in the direction of the arrow,
FM(75Ω) | GND | AM |
| SUB |
| WOOFER | |||
DAB |
|
|
| |
|
|
|
| |
ANTENNA |
|
|
|
|
|
| DIGITAL |
|
|
|
| OUT | R | L |
and keep this condition.
TAPE | MD | DVD |
IN | IN | IN |
L
R
L
R
OUT OUT
AC IN
OPT
SPEAKERS
MODEL NO. CR601
•Don’t connect more than one wire to each speaker terminal. Doing so may damage the CR601.
•If you want to connect a single speaker instead of a pair, connect it to either the left or right speaker terminals, not both.
4.Insert the bare part of the wire into the hole in the side of each terminal.
5.Put the terminal lever
back, and make sure it is fastened securely by pulling the wire lightly.
9
