ENGLISH
Symptom | Cause | Measures | Page |
|
|
|
|
The RDS (Radio Data | • The current FM station does | • Tune into a station that | 17 |
System) doesn’t seem | not support RDS. | supports RDS. |
|
to work? | • The signal strength is poor, or | • Install an outdoor FM antenna, | 8 |
| there’s too much interference. | change the position or |
|
|
| direction of your outdoor FM |
|
|
| antenna, and keep it away |
|
|
| from fluorescent lights. |
|
|
|
|
|
CD playback skips? | • The CR601 is subject to | • Install the CR601 somewhere | 2 |
| vibration. | free of vibration. |
|
| • The disc is dirty. | • Remove the disc and clean it. | 3 |
| • The disc is very scratched. | • Buy a new disc. | 3 |
|
|
|
|
Noise is generated. | • DTS CD is being replayed. | • Do not replay DTS CD, which | 2 |
|
| is not supported by the CR601. |
|
|
|
|
|
Can’t play a CD? | • The disc is upside down. | • Load the disc with the label- | 12 |
|
| side facing up. |
|
| • The disc is dirty. | • Remove the disc and clean it. | 3 |
| • Condensation has formed | • Remove the disc and leave the | 2 |
| inside the CR601. | CR601 turned on for several |
|
|
| hours until the condensation |
|
|
| has evaporated. |
|
| • The | • See “Disc Notes”. | 2 |
| nonstandard. |
|
|
|
|
|
|
It takes a long time to | • It may take a longer time to | • This is not a malfunction. | 2 |
read CD/MP3. | read CD/MP3 with many track |
|
|
| numbers. |
|
|
|
|
|
|
It takes a long time to | • The disc is dirty. | • Remove the disc and clean it. | 3 |
locate certain tracks. | • The disc is very scratched. | • Buy a new disc. | 2 |
|
|
|
|
The clock is wrong? | • CT (Clock Time) information | • Set the clock by Manual | 24 |
| has been taken from a radio | operation. |
|
| station in another time zone. |
|
|
|
|
|
|
No sound is output | • While a timed recording task is | • To hear what’s being recorded, | 24 |
when a timed playback | in progress, the output of the | press the MUTE button to |
|
or recording task starts? | CR601 is muted. | cancel the Mute function. Press |
|
|
| it again to mute the CR601. |
|
| • For timed playback, the | • Set the volume to a suitable | 11 |
| volume is determined by the | level. |
|
| VOLUME control. |
|
|
|
|
|
|
Standby indicator | • The protection circuit may be | • Make sure not to | 9 |
flashes. | activated. | the positive and negative |
|
|
| speaker wires. |
|
|
|
|
|
Abnormal Behavior:
The CR601 contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
28