Marantz DV7110 manual Before Using, Checking Accessories, Preparing the Remote Control

ENGLISH

Before Using

Checking Accessories

Please confirm that the following were received with the player.

Preparing the Remote Control

Inserting batteries into the remote control

1While pushing the tab on the

battery compartment cover toward the center of the remote, pull out in the direction indicated by the

Audio / Video cord

Remote Control cord

Remote control unit

	RANDOM	3	6	9	CLEAR	MENU
	REPEAT	2	5	8	+10	0
	A-B
OPEN/CLOSE	VIDEO ON/OFF	1	4	7	T-C	TOP MENU

RETURNENTER

AUDIO	LAST MEMORY	CONDITION MEMORY
SUBTITLE	OSD	DIMMER
ANGLE	PROGRAM	SETUP

REMOTE CONTROLLER RC7010DV

arrow.

2Insert batteries.

Make sure to match the plus (+) and minus

(–) polarity guides on the batteries with the marks inside the battery compartment.

3Close the cover.

Notes

AA/R6P batteries

Operating instructions (this manual)

•Do not mix old and new batteries.

•When replacing batteries, use all new batteries.

•When not using the remote control for a long period of time (over 1 month), remove the batteries to avoid possible damage from battery corrosion. If battery leakage occurs, wipe the battery liquid from the battery component, then insert new batteries.

Remote control operation

When operating the remote control, point it at the remote sensor located on the player’s front panel. The remote control can be used up to 17 feet (5 m) from the player and within a 30° angle on each side of the sensor.

1

30° 30°

Within about 17 feet

1 2 3

4 5 6

7 8 9

Notes

•Exposing the remote sensor to direct sunlight or strong light may cause faulty operation.

•When using this DVD player as a stand-alone player, set the REMOTE CONTROL switch on the rear panel to INTERNAL and set the RS-232C switch to RC-5/6.

8